Directed Electronics VIPER 4103XV - Manual (Page 11)

5 © 2009 Directed Electronics. All rights reserved.
When you are ready to drive the vehicle:
Insert the ignition key and turn it to the ON (not the START) 1.
po sition.
Press the brake pedal. The remote start system shuts down and the
2.
motor continues to run because the ignition has been turned on.
Note:
If the brake pedal is pressed before the key is in the ON position,
the engine will shut down.
While the vehicle is running during remote start operation, the system
will monitor the ve hi cle and will automatically shut down the engine if the
system receives any of the following shut-down inputs:
The brake pedal is pressed. •
The hood is opened. •
The shutdown toggle switch is put into the OFF position. •
The pre-programmed run time (12, 24, or 60 minutes) has elapsed. •
Remote control button • is pressed 1 time to start the vehicle.
➢
Rear Defogger
To turn the rear defogger output Off:
Simultaneously press & release the 1.
�������
+ +
�������
buttons on the
remote control.
The lights flash 2 times.
2.
The rear defogger output will no longer activate when the vehicle 3.
is remote started.
Note: If the remote start is On, the parking lights turn Off then flash
2- times before returning to normal output. The defogger output, if ac-
tive, will cease.