Argox AS Series - Manual (Page 37)

32
Scan
Position indication (8110 excluded): If the function is
enabled, scan beam will flash as a pointer to help you aim at
the bar code prior to scanning. The code will not be scanned
until you press the trigger.
Stand mode selection: Normally activated with continuous
mode. If it is set as LED “off”, the scanner red beam will turn
off automatically in case not used, but will turn on again
immediately when scanning bar codes. This is available for
all ArgoxScan series scanners (AS-8000/AS-8120/AS-8150/
AS-8250/AS-8310/8312)
PCS Enhancement: The reading performance under low
PCS value will be improved when this function is enabled. It
is recommended to set “Double confirm” (7AD) other than
“00”.