Argox G-6000 - Manual (Page 11)

Operator Controls
LED Indicators
Front Panel
There are three LED indicators on the front panel, “READY”, “MEDIA” and
“RIBBON”. These indicators display the operation status of the printer.
The front panel includes
✸ READY The READY indicator will remain lighted except if any of the
following conditions prevail.
- The printer is at PAUSE state.
- A fault condition
.
✸ MEDIA The MEDIA indicator will remain on for the normal
operation of the printer.
Blinking – Media run out
.
✸ RIBBON ON III – under thermal transfer mode with ribbon installed.
OFF – under direct thermal mode. ( no ribbon installed )
ON - Bit 1 of DIP swith is at ON position.
Blinking – Ribbon run out .
- 3 LED indicators (READY, MEDIA and RIBBON)
- 3 buttons (FEED, PAUSE and CANCEL)
- A LCD display
21 22
OFF - Bit 1 of DIP swith is at OFF position.