beautypg.com

Shifting procedure - nv 144 transfer case – Dodge 2007 HB Durango User Manual

Page 262

background image

Shifting Procedure - NV 144 Transfer Case

4WD to 4WD LOCK or 4WD LOCK to 4WD
With the key ON and the engine either OFF or RUN-
NING, rotate the transfer case switch, located on the
instrument panel to the desired position.

NOTE:

Delayed shifting out of 4WD LOCK may be

experienced due to uneven tire wear, low tire pressure, or
excessive vehicle loading.

NOTE:

If any of the requirements to select a new

transfer case position have not been met, the transfer case
will not shift. The indicator light will flash and the
current transfer case position will be maintained. To retry
a selection, turn the control knob back to the current
position, wait five (5) seconds, and retry the shift.

NOTE:

The 4x4 system will not allow shifts between

4WD/4WD LOCK if the rear wheels are spinning (no
traction). In this situation the position indicator light will
continue to flash. At this time, reduce speed and stop
spinning the wheels to complete the shift. There may be
a delay up to 13 seconds for the shift to complete after the
wheels have stopped spinning.

NOTE:

The ignition key must be ON for a shift to take

place and for the position indicator lights to be operable.

262

STARTING AND OPERATING

This manual is related to the following products: