beautypg.com

Using homelink, Erasing homelink buttons, Reprogramming a single homelink button – Dodge 2007 HB Durango User Manual

Page 165

background image

NOTE:

If programming a garage door opener or gate

operator, it is advised to unplug the device during the

ЉcyclingЉ process to prevent possible overheating.

Using HomeLink
To operate, simply press and release the programmed
HomeLink button. Activation will now occur for the
trained device (i.e. garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.). For convenience, the hand-held transmitter of the
device may also be used at any time. In the event that
there are still programming difficulties or questions,
contact HomeLink at: www.homelink.com or 1-800-355-
3515

.

Erasing HomeLink Buttons
To erase programming from the three buttons (individual
buttons cannot be erased but can be

ЉreprogrammedЉ -

note below), follow the step noted:

• Press and hold the two outer HomeLink buttons, and

the EVIC will display “CLEARING CHANNELS”, do
not

release

the

buttons

until

“CHANNELS

CLEARED” is displayed on the EVIC (after approxi-
mately 20 seconds). Release both buttons. Do not hold
for longer that 30 seconds. HomeLink is now in the
train (or learning) mode and can be programmed at
any time beginning with

ЉProgrammingЉ - step 2.

Reprogramming a Single HomeLink Button
To program a device to HomeLink using a HomeLink
button previously trained, follow these steps:

1. Press and hold the desired HomeLink button. DO
NOT

release the button.

2. The EVIC will display “CHANNEL X TRANSMIT” for
20 seconds and then change to “CHANNEL X TRAIN-
ING”. Without releasing the HomeLink button, proceed
with

ЉProgrammingЉ step 2

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

165

3

This manual is related to the following products: