Aplex Technology ARCHMI-912 - Manual (Page 29)

ARCHMI-9XX Series User Manual 28
Procedures of CMOS clear:
a) Turn off the system and unplug the power cord from the power outlet.
b) To clear the CMOS settings, use the jumper cap to close pins 1 and 2 for
about 3 seconds then reinstall the jumper clip back to pins open.
c) Power on the system again.
d) When entering the POST screen, press the or key to enter
CMOS Setup Utility to load optimal defaults.
e) After the above operations, save changes and exit BIOS Setup.
9. BAT2:
(2.0mm Pitch 1x10 Wafer Pin Header), Smart battery Interface.
Pin# Signal Name
Pin1 VCC_BAT1
Pin2 VCC_BAT1
Pin3 VCC_BAT1
Pin4 SMB_DAT_SW
Pin5 SMB_SCL_SW
Pin6 BAT1_TEMP
Pin7 Ground
Pin8 Ground
Pin9 Ground
Pin10 SET_BAT1_ON
Function Specifications
Nominal voltage (3S1P) 11.1~12.6V
Charge voltage 12.6V
Charge current 0.5C
10. BAT_LED:
(2.0mm Pitch 1x4 Wafer Pin Header), The Charge status indicator for BAT2.
Pin1-Pin3: Charge LED status.
Pin2-Pin3: Discharge LED status.
Pin4-Pin3: EC LED status.
Pin# Signal Name
Pin1 BAT2_LED+