Aplex Technology APC-3517B - Manual (Page 18)

APC-3X17B User Manual 18
Open NORMAL
(Default)
Close 1-2 Clear CMOS
Procedures of CMOS clear:
a) Turn off the system and unplug the power cord from the power outlet.
b) To clear the CMOS settings, use the jumper cap to close pins1 and 2 for about 3
seconds then reinstall the jumper clip back to pins open.
c) Power on the system again.
d) When entering the POST screen, press the or key to enter CMOS Setup
Utility to load optimal defaults.
e) After the above operations, save changes and exit BIOS Setup.
3. BAT1 :
(1.25mm Pitch 1X2 box Pin Header) 3.0V Li battery is embedded to provide power for
CMOS.
Pin#
Signal
Name
Pin1 VBAT
PIN2 Ground
4. DCIN:
(5.08mm Pitch 1x3 Pin Connector),DC9V ~ DC32V System power input connector。
Pin#
Power
Input
Pin1
DC+9V~32
V
Pin2 Ground
Pin3 Ground
Power Mode
Location
(5.4.4.) Location
(5.4.5.) Location (5.4.6.)
ATX