DigiTech RP50 - Manual (Page 20)

Chorus ( C1-C9 )
A Chorus adds a short delay to your signal. The delayed signal is modulated in and out
of tune and then mixed back with the original signal to create a thicker sound, and
stereo image. Use the Value buttons to select one of the nine Chorus settings.
Flange ( F1-f9 )
A Flanger uses the same principle as a Chorus but uses a shorter delay time and adds
regeneration (or repeats) to the modulating delay. This results in an exaggerated up
and down sweeping motion to the effect. Use the Value buttons to select one of the
nine Flanger settings.
Phaser ( P1-p9 )
A phaser splits the incoming signal, and changes the phasing of the signal. The signal is
taken in and out of phase and mixed back in with the original signal. As the phasing
changes, different frequencies get canceled resulting in a warm sort of twisting sound.
Use the Value buttons to select one of the nine Phaser settings.
Tremolo ( t1-t9 )
A Tremolo effect modulates the volume of the signal at an even rate. Use the Value
buttons to select one of the nine predetermined settings.
Panner ( n1-n9 )
An Auto Panner modulates the sound from left to right at an even rate. Use the Value
buttons to select one of the nine Panner settings.
16