Aplex Technology APC-3229A - Manual (Page 32)

APC-3XX9A User Manual
32
Chapter 3 BIOS Setup
3.1 Introduction
This section explains how to use the UEFI Setup Utility to configure your system. The UEFI chip on
the motherboard stores the UEFI Setup Utility. You may run the UEFI Setup Utility when you start up
the computer. Please press or during the Power-On-Self-Test (POST) to enter the UEFI
Setup Utility, otherwise, POST will continue with its test routines. If you wish to enter the UEFI Setup
Utility after POST, restart the system by pressing + + , or by pressing the reset
button on the system chassis. You may also restart by turning the system off and then back on.
3.1.1 UEFI Menu Bar
The top of the screen has a menu bar with the following selections:
Main To set up the system time/date information
Advanced To set up the advanced UEFI features
H/W Monitor To display current hardware status
Boot To set up the default system device to locate and load the Operating System
Security To set up the security features
Exit To exit the current screen or the UEFI Setup Utility
Use < > key or < > key to choose among the selections on the menu bar, and then press
to get into the sub screen. You can also use the mouse to click your required item.