Amina AIW750i - Manual (Page 23)

Plastering and decorating
01
02
03
Fill gap between speaker and surrounding
area
It is important to ensure that plaster is
pushed into the 2mm (5/64”) gap that
surrounds the speaker. This will create
a strong bond between the edge of the
speaker and the edge of the wall and will
prevent cracks appearing in the plaster
skim finish.
Use a low shrinkage repair plaster such as
British Gypsum Easi-fill®
IMPORTANT: There MUST be a gap of 2mm
(5/64”) all the way around the speaker
edge. If there isn’t simply remove the
speaker and increase the aperture size
accordingly (plasterboard installations
only)
Clean speaker surface
Clean speaker surface of dust and grease
with a solvent wipe or damp (not wet)
cloth. Ensure that silicone sources have not
been used in the vicinity.
Apply joint tape
Apply the self-adhesive fibreglass
joint tape (supplied by Amina or your
distributor) to the speaker face. Ensure
it covers the entire speaker face and the
plasterboard joints
D
Finishing
19
Min 50mm