AMETEK XG 850 Watt Series Rack-Mount - Manual (Page 9)

XG 850 Watt Rack Mount Kit Options
M370078-05 9
6. Mount cabinet section into rack between upright rails using:
• (4) Bar nuts (SPO-623 sold separately)
• (6) #10 × 0.375 flat head countersunk Phillips SST screw (not supplied by Jonathan).
Two for each side. See Figure 8.
7. Install chassis.
8. Cycle chassis twice (push in and out two times).
Ensure that rollers are engaged and the lock functions properly.
Figure 7 Attaching Front And Rear Bracket To Cabinet Section
Important: Do not tighten hardware completely.
SPO-622 shown
Bar nut SPO-623. Install temporarily
if using Type 1, 2, 3, rails (x 2).
Important: The hardware used will change depending on the type of mounting hole available in your
equipment rack. Ensure rails are level.
Figure 8 Mounting Cabinet Section Into Rack
SPO-683 shown
SPO-622 shown
Only one screw
used on front side