AMETEK XG 850 Watt Series Rack-Mount - Manual

This Application Note provides information on the options available for rack mounting the XG
series and provides installation instructions for the rack mount kit options. The complete set of
instructions for installing the XG power supplies are provided in the XG 850 Watt Series
Programmable DC Power Supply Operating Manual (Part number: M370078-01 for firmware
v1.09 and below, and M370186-01 for firmware v1.11 and higher). See the Installation chapter
for additional information.
Rack Mount Kit Options
Table 1 describes the options available for rack mounting the XG and provides the part numbers
for each option.
XG 850 Watt Single and Dual
Figure 1 shows the rack mount kit options for installing the XG 850 Watt into a rack.
XG Programmable Power Supplies:
Rack Mount Kit Options and
Installation Instructions Application Note
XG 850 Watt
M370078-05 Rev C
Table 1 Rack Mount Options
Unit Option A: Rack Mount with Rails Option B: Rack Mount with Slides
XG 850 Watt Single RM-S-XG1 and RM-XG1 RM-S-XG1. See Table 2 on page 7.
XG 850 Watt Dual RM-D-XG1 and RM-XG1 RM-D-XG1. See Table 2 on page 7.