beautypg.com

Reflex power™ mating connectors for acps module, Interface connector, Interface pinout – AMETEK ACPS User Manual

Page 2

background image

Technical Note

ReFlex Power™ Mating Connectors for ACPS Module

Document No. W380272-01 Rev D •

1/23/2009

©2008 AMETEK Programmable Power, Inc. • All rights reserved. • AMETEK is a trademark of AMETEK, Inc.

9250 Brown Deer Road, San Diego CA 92121 • Tel: 858-450-0085 • Fax: 858-458-0267 • email:

[email protected]

• Web:

www.programmablepower.com


2 of 4

Pins A1 through A6 insertion/extraction: Positronic Industries P/N 4311-0-0-0

INTERFACE CONNECTOR

External isolated digital and analog control interface.

Connector: Positronic Industries P/N SD9M1000Z, AMETEK P/N 856-214-09

Crimp contacts: Positronic Industries P/N MC7520D (initially supplied with connector)

Backshell: Positronic

Industries

P/N D9000Z00, AMETEK P/N 856-247-10

Wire size:

Maximum gauge 20 AWG (recommended)
Maximum length 10 meters (can be extended subject to the environment, cable type, and interface circuits).

INTERFACE PINOUT

Figure 2. Interface Connector, Front Panel View, and Interface Connector Wiring Diagram

Pin

Name Function

Signal

Level

1 ENA

1

Input: module output enable

TTL logic level

6 ENA-RTN

1

Input: return for ENA signal; connected to Pin-7/8

Signal common

2 Reserved

7 Reserved

3 Reserved

8 Reserved

4 Reserved

9 Reserved

5 CHAS-GND

Shield

ground

Chassis

ground

1

Enable signal is internally pulled up to +5 V with a 10 K resistor. To enable the module, the signal is pulled low (<= 0.5 V) with respect to the ENA RTN

signal; this may also be accomplished by shorting Pin 1 to Pin 6.