AMETEK M133 - Manual (Page 5)

Sorensen DCS Series Manual Addendum
M133 / M135 / M136 Operation, Remote Programming 3
3.1.1 Output SCPI Commands Relay PCB
3.1.1.1 Calibration SCPI Commands
CAL:INIT:VOLT ; Stores fixed output voltage at power up
CAL:INIT:VOLT:PROT ; Sets over voltage protection level
CAL:INIT:CURR
; Stores fixed output current at power up
CAL:UNLOCK “6867”
; Security code store unlock
CAL:STORE ; Stores calibration parameters
CAL:LOCK ; Locks calibration parameters
3.1.3.2 Output SCPI Commands
OUTP:ISOL OFF ; Sets the isolation relay control signal off
OUTP:POL NORM ; Sets normal polarity
or
OUTP:POL INV ; Reverses output polarity
OUTP:ISOL ON
; Sets the isolation relay control signal ON
OUTP:SENS ON ; Sets the sense relay signal open or closed