AMETEK M133 - Manual (Page 4)

Manual Addendum Sorensen DCS Series
2 M133 / M135 / M136 Operation, Remote Programming
2.1 CONFIGURATION
The M9 (GPIB) or M130 (LXI Ethernet) and the Relay PCB options are
installed at the factory. Use the setup procedure described in the M9 or
M130 programming manual section 2 to configure the M9 or M130 and
Relay PCB for your system and application.
2.2 EXTERNAL SIGNAL CONTROL USER CONNECTOR
The control signals accessible at connector J5 are the M9 signals
extended thru the relay PCB from the M9 external user control signals
are as described in paragraph 2.3 of the M9 programming manual.
The control signals accessible at connector J3 are the DCS 1KW J3
signals extended thru the relay PCB from the DCS 1KW rear panel are
as described in paragraph 2.4.2
– 2.4.3 of the DCS 1KW Operation
Manual. NOTE: Do not use the sense connections at J312
and J3-13
– Sense connection must be made at the J9
Pins 1 and 2.
A 6-pin Molex J9 provides access to the isolated remote sense signals
J9-1 and J9-2. The mating receptacle for the 6-pin connector is Molex
43025-0600. Remote sense J9-1 connects to the +side of the load and
J9-2 to the
–side. Also accessible is the non-isolated DCS output voltage
on J9-5 (+) and J9-6 (-).
Molex Pin Description
1 Isolated Remote Sense (+)
2 Isolated Remote Sense (-)
3&4 Not Used
5 Non-Isolated DCS output Voltage +
6 Non-Isolated DCS output Voltage -
Table 1 External User Connector J9
3.1 IEEE 488.2 or Ethernet and SCPI COMMAND
OPERATION
The M9 and Relay PCB operation by remote programming using the M9
IEEE-488.2 and SCPI command sets are as described in section 3 of the
M9 programming manual.