American Time Wireless Indoor Strobe/Siren - Manual (Page 5)

© American Time
Wireless Indoor Strobe/Siren
Wiring
Wiring of the Wireless Indoor Strobe/Siren consists of three wires—Black-HOT; White-NEUTRAL; Green-GROUND.
n Note: When wiring any high voltage device, follow all local and national electrical codes. A licensed electrician is required
for any high voltage wiring.
There are two openings in the Wireless Indoor Strobe/Siren enclosure where wiring may be accessed. One opening is
located on the back of the enclosure (standard); the other opening is located on the bottom of the enclosure.
A hole plug is supplied to close the opening not being used.
Setup
Once the Wireless Indoor Strobe/Siren is wired and powered up, it may be tested or activated by using the MAN button on
the system controller or via the Circuit tab of the Remote Connect web interface (using a SiteSync IQ system controller with
the Ethernet option and a computer with internet access).
See the SiteSync IQ Operation & Installation Manual for additional support information.
Changing Alarm Tones and Alarm Timing - S1
The strobe/siren's alarm tone may be changed by removing the lens cover and changing the setting on dip switch S1. Use
the supplied key to remove the lens.
The table below shows the different alarm tones available and the proper dip switch setting for each.
Installation Instructions
3
1-ON 0=OFF
*Factory Default
Settings