American Time Wireless Indoor Horn - Manual (Page 5)

© American Time
Wireless Indoor Horn
Installation Instructions
Wiring
Wiring of the Wireless Indoor Horn consists of three wires—Black-HOT; White-NEUTRAL; Green-GROUND.
n Note: When wiring any high voltage device, follow all local and national electrical codes. A licensed electrician is required
for any high voltage wiring.
There are two openings in the Wireless Indoor Horn enclosure where wiring may be accessed. One opening is located on
the back of the enclosure (standard); the other opening is located on the bottom of the enclosure.
A hole plug is supplied to close the opening not being used.
Setup
Once the Wireless Indoor Horn is wired and powered up, it may be tested or activated by using the MAN button on the
system controller or via the Circuit tab of the Remote Connect web interface (using a SiteSync IQ system controller with the
Ethernet option and a computer with internet access).
See the SiteSync IQ Operation & Installation Manual for additional support information.
3