American Time Synchronous Wired and Electronic Movement - Manual (Page 5)

American Time - 140 3rd Street South - PO Box 707 - Dassel, MN 55325-0707
5
See Fig. 68A
8. With throwout lever A at the point of drop-off on
hourly correction lobe B, and the aligned lever out of
the notch in the stop disc (Fig. 66), the tail (C) of the
throwout lever should still be on 12 hour latch lever D
(as illustrated). Adjustment is made by forming tail C
accordingly.
See Fig. 68B
9. With power “ON” and the correction solenoid
energized for 12 1 /
2
seconds, there should be a slight
clearance at A. Adjustment is made by forming the tail
of the throwout lever accordingly. (Adjustment number 8
must be maintained)
See Fig. 69
10. With the aligned lever engaged in the stop disc
notch, and the 12 hour latch lever off the stud (Fig. 68B),
there should be an overlap at A of .313" ( 1 /
32
") between
the 12 hour latch lever and the throwout lever. Notch B
in the 12 hour latch lever is provided to allow the lever
to be formed accordingly.
Fig. 68A
Fig. 68B
Fig. 69