beautypg.com

Troubleshooting – Denon DJ RCD-CX1 User Manual

Page 32

background image

Get
ting Star

ted

Connections

Set
up

Pla
ybac

k
Set
ting the

Timer

Other F

unctions

ENGLISH

Specifications

If a problem should arise, first check the following:
1. Are the connections correct?
2. Is the set being operated as described in the owner’s manual?
3. Are the other components operating properly?
If this unit does not operate properly, check the items listed in the table below. Should the problem persist,
there may be a malfunction.
In this case, disconnect the power immediately and contact your store of purchase.

Symptom

Cause

Countermeasure

Page

Set does not
operate properly.

• External noise or interference is

causing the set to malfunction.

• Reset the microprocessor.

27

When the power
is turned on, the
power indicator
does not light
and no sound is
produced.

• Connection of the power cord is

faulty.

• Check that the power plugs are

securely inserted into the RCD-
CX1’s AC inlet and the wall power
outlet.

12

The power
indicator lights
but no sound is
produced.

• The speaker cables are not

properly connected.

• The function (input) is incorrect.

• The volume is set too low.

• Connect securely.

• Switch to the correct function

(input).

• Adjust the volume to an

appropriate level.

9

15

15

No sound is
produced from
one side.

• The speaker cables are not

properly connected.

• The input cables are not properly

connected.

• The left/right balance is off.

• Connect securely.

• Connect securely.

• Adjust the left/right balance.

9

10, 11

15

For stereo
sources, the
positions of the
instruments are
inverted.

• The connections of the speaker

cables or input cables are
inverted.

• Check

and

remedy

the

connections.

9 ~ 12

G

GeneralH

Symptom

Cause

Countermeasure

Page

Set does not work
properly when
remote control
unit operated.

• Batteries are worn.
• You are operating outside of the

specified range.

• Obstacle between main unit and

remote control unit.

• The batteries are not inserted in

the proper direction, as indicated
by the polarity marks in the
battery compartment.

• The set’s remote control sensor

is exposed to strong light (direct
sunlight, inverter type fluorescent
bulb light, etc.).

• Replace with new batteries.
• Operate within the specified

range.

• Remove the obstacle.

• Insert the batteries in the

proper direction, following the
polarity marks in the battery
compartment.

• Move the set to a place in which

the remote control sensor will
not be exposed to strong light.

4
4

4

4

4

G

Remote Control UnitH

Troubleshooting

Tr

oubleshooting

1.RCD-CX1_ENG.indd 28

2008/05/30 11:20:45