Aervoe 8-inch Oscillating Fan - Manual

Max Burton ® 8” Oscillating Fan #6950
IMPORTANT SAFEGUARDS
Read all instructions before operating •
Do not immerse cord or unit in water or other liquids •
To avoid electric shock or injury do not use for anything other than •
its intended use
Do not use without the fan blade guard in place or with loose fan •
blades, or parts.
Keep fingers and other objects away from fan blades •
Do not install where fan would obstruct safe vehicle operation or •
visibility
Never install on or near vehicle air bags •
Unplug when not in use •
Administer close supervision when using around children •
PARTS IDENTIFICATION
MOUNTING
There are two mounting options available:
Use the spring clamp to attach to the dashboard or other secure 1.
structure.
Attach more permanently to a horizontal or vertical surface by 2.
removing the spring clamp assembly and attach with the included
hardware.
CAUTION: For safety, the fan should be mounted 2-3 feet from the
driver and passengers.
OPERATION
Make sure the fan is attached using either of the two methods 1.
above.
Plug the 12-V DC plug into any 12-V power receptacle or cigarette 2.
lighter. The LED Indicator light will illuminate on the plug.
Select either 3. FAST or SLow operation on the back of the motor to
adjust the speed. The center position is the oFF position.
Use the 4. TILT & SwIVEL ADjUSTMENTS to change angle of the
fan.
The oSCILLATIoN SwITCH may be used to choose between 5.
oscillation or stationary position. Slide the switch down for
oscillation and up for stationary.
The fan may be used with our 200 watt Converter #6993 to allow 6.
it to plug into any 120V electrical outlet. Available from your local
retailer or www.aervoe.com.
CLEANING
Unplug the fan from the 12-volt power receptacle before cleaning.
Dust with a soft cloth or other dusting item. Use a damp rag to clean
tougher dirt or grime as needed. Do not submerge any part of the fan.
CAUTION: If the fan blade guard was removed for cleaning, ensure it
is properly re-attached before using again.
TROUBLESHOOTING
If the 12-volt circuit fails to operate, try the following suggestions:
Unplug from the power supply an make sure that the receptacle is 1.
clean. Do NoT USE METAL TooLS. If cleaning is needed, use
only insulators, such as wood.
Check the plug’s fuse. Carefully unscrew the plug’s top section. 2.
Remove and check the fuse with the proper electronic meter. If
defective, replace with correct fuse (see specification for type).
Also check the vehicle’s fuse panel.
Some cigarette lighters have a separate circuit breaker located 3.
directly behind the cigarette lighter receptacle. If you lighter
is not working, this circuit breaker may have blown and could
require replacement. Consult your vehicle owner’s manual for
replacement.
Mounting Clamp
12-Volt Plug
Oscillation/Stationary Switch
On/Off & Speed Adjustment
Tilt & Swivel
Adjustment
Fan Blade Guard
Fan Blades