Fireplace installation, Continued – Desa (V)T36NA SERIES User Manual
Page 23
111250-01C
For more information, visit www.desatech.com
For more information, visit www.desatech.com
23
23
FIREPLACE INSTALLATION
Continued
FIREPLACE INSTALLATION
Installing Optional Brick Liner Models BL36D(S) and BL36DH(S)
Installing Logs, Lava Rock and Glowing Embers
Figure 43 - Installing Rear Brick Panel
Figure 44 - Installing Left Side Brick Panel
Rear Brick Panel
Left Side
Brick Panel
INSTALLING LOGS, LAVA ROCK AND
GLOWING EMBERS
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with fireplace.
Open louvers, remove screen, unlock door latches, and open glass
door. See steps 1 and 2 of Removing/Replacing Glass Door, page 22.
Install logs according to instructions for fireplace model numbers.
1.
Place log #1 (rear log) on top of grate. Make sure the notches
in the bottom of the log fit over the grate (see Figure 45).
2.
Rest log #2 (large front log) on the pins on the front part of the grate
(see Figure 46, page 24).
1
Figure 45 - Installing Log No. 1
INSTALLING OPTIONAL BRICK LINER
MODELS BL36DA(SA) AND BL36DHA(SA)
WARNING: If fireplace has been running, turn
off and unplug fireplace. Let cool before installing
brick liner.
This brick liner kit is optional. You may purchase brick liner from
your local retailer or see Accessories, page 37.
CAUTION: Always handle brick panels with two
hands. Do not force brick panels into place. Exces-
sive force will break brick panels.
1.
Remove top and bottom louvers to allow access to door latches.
2.
Unlock door latches and open glass door. See steps 1 and 2 of
Removing/Replacing Glass Door.
3.
If installing brick liner in new fireplace, go to step 4 on page
23. If installing brick liner in an existing fireplace, carefully
remove logs, lava rock, and ember material.
4.
Remove three screws from deflector shield on the inside top
of firebox. Set shield and screws aside.
5.
Install rear brick panel first. Rest bottom edge of panel on back
edge of grate (see Figure 43).
6.
Install left side brick panel by sliding it between the grate and
the side of the firebox (see Figure 44).
7.
Install the right brick panel using the same method described
8.
Replace deflector shield using screws removed in step 4.
9.
Follow instructions on page 24 to install logs, lava rock, and
ember material.
10. Close glass door, lock latches on top and bottom of door and
replace screen (see steps 5 and 6 of Removing/Replacing Glass
Door, page 22).
11. Close top and bottom louvers.