ZVOX Audio SoundBase® 570 - Manual

“TV base” position
Shelf position
Place the SoundBase
on stable, flat surface.
Ensure all components
are stable and secure. Optical Audio Output
Connect one end of
an optical digital cable
to the TV’s Audio Out
optical jack.
With an optical digital
audio connection, you
should hear the TV
sound through the
SoundBase with the
SoundBase volume set
to 12-15.
If you don’t hear sound
or if you did not use
an optical connection,
press the INPUT button
on the SoundBase re-
mote control to select
the correct input.
SoundBase’s Optical
Audio Input #1
Connect the other end
of the optical cable
to the SoundBase’s
optical input jack #1.
Connect the AC
power cord to
the back of the
SoundBase. Leave
the Power Switch in
“Off”. Then insert the
AC plug into an AC
power receptacle.
OFF
Flip on the Power.
Connect to
Optical Audio
Output of TV.
Connect to
Optical Audio
Input of
SoundBase.
Confirm you hear
TV sound through
the SoundBase.
ON
RCA Jack Analog
Audio Out
A red/white pair of RCA jacks
on the back of the TV labeled
OUTPUT. Do not connect to
RCA jacks labeled INPUT.
Coaxial Digital
Audio Output
(Single RCA jack,
may be orange)
Any cable with an RCA plug
at each end can be used.
“Minijack” Analog
Audio Out
Some TVs use a minijack
output or headphone jack.
Do not use a minijack
labeled INPUT.
Position the
SoundBase.
Connect the
power cord.
1
2
or the front panel.
Back of SoundBase
Back of SoundBase
Back of SoundBase
Input 1
Input 1
Input 1—digital (optical jack)
Input 3—digital (coaxial jack)
Input 2—digital (optical jack)
Input 4—analog (RCA jacks)
Input 5—analog (RCA jacks)
Input 6—analog (front minijack)
Bluetooth device
© 2014 ZVOX Audio LLC.
ZVOX
®
SoundBase
®
870/770/670/570 Quick Setup
Other Possible TV Audio Outputs
1
a
b
c
2 3 4
5
6
Select the TV input using
the remote control
INPUT
DIALOG
EMPHASIS
SURROUND
TREBLE BASS
OUTPUT
LEVELING
POWER
VOLUME MUTE
SoundBase
Back of SoundBase
Back of TV
Back of SoundBase
AC Power
Receptacle
Back of TV
Back of TV
Back of TV