Vectronics HFT-1500 - Manual (Page 6)

HFT-1500 Digital Antenna Tuner with Roller Inductor Owner's Manual
4
REAR PANEL CONNECTORS
1. RF INPUT
Coaxial connector for input from SWL receiver or transmitter.
2. COAX 1
Coaxial connector for output to Antenna One.
3. COAX 2
Coaxial connector for output to Antenna Two.
4. BYPASS
Coaxial connector for output to dummy load or third coax output. Bypasses tuner, but
meter circuits and digital bargraph remain active if AC adapter is connected to the
jack located on the rear panel.
5. GROUND
Post/Wing-nut type ground connector.
6. BALANCED OUTPUT
Two Derlin High Voltage post for output to RF balanced twin-lead antennas. (Note
that jumper must be used as shown by the dotted line.)
7. END FED WIRE
Derlin High Voltage post for output to a single-wire antenna. (Do not use jumper.)