Transystem 760 - Manual (Page 10)

G-Log 760 GPS Recorder
V1.1 10
data is valid for 7 days after each download.
2-8. Getting Started
Please follow the procedure step by step.
Step 1 Charging the battery
Connect your USB cable between G-Log 760 and the power source. Charging time is about 3~4
hours and you can charge from PC/ Notebook’s USB HOST or from cigarette-lighter in car or
home adapter.
For the 1st time you use the G-Log 760, please charge battery until it is full. Red Power LED will
be On during charging cycle and 2 Green LEDs and 1 Red LED will be all On once the charging is
completed.
Step 2 Turn on your G-Log 760 and get position fix
Turn on your GPS G-Log 760 by press-and-hold the power button for 3 seconds. Power LED will
turn on after power on sequence is completed. The orange GPS status LED will stays on before
G-Log 760 get GPS position fix. Make sure your GPS G-Log 760 has clear sky view at this stage
of acquiring satellite signal. Depending on your surroundings, it normally takes around 40 seconds
to 1.5 minutes before GPS status starts to blink which means G-Log 760 has acquired necessary
satellite signals and get position fix..
Step 3 Log your position
GPS G-Log 760 will start logging your position once it locks to satellites signal. It will log and
mark position upon press of POI button. A vibrator is used as means of confirmation. Optional
buzzer can also be used for confirmation purpose. This is only valid for specific setting when
ex-factory.
Step 4 Download logged data