Operation, Set clock, Ignition – Toyotomi LC-32F User Manual

Page 6

SET CLOCK

It is only possible to set the correct time, when the heater is
connected to the mains and not burning.

1. Use the Adjustment Keys (▼ hour / ▲ min.) to set the time.

2. To set the time, press “hour” and “min.” set

buttons. Individual motions will increase the
time by one unit; holding continuously will
raise either the “hour” or “min.” rapidly. After
approximately 10 seconds the blinking will
stop and the setting will be locked. 5 Minutes
after switching off the heater, the information
on the display will disappear and the heater will automatically switch into the stand-by
position.

1. Just press the

button to ignite the heater. The

button will start blinking, indicating

that the ignition procedure has started. This will take a short while.

2. After this time heater will automatically ignite and The button will cease its flashing. The

Operation Lamp will remain alight so long as heater is burning.

NOTE: If using your heater for the first time, or after long term storage, ignition may not

take place on the first try. Press the

button again.

NOTE: Fuel pump may produce an audible operating noise at ignition. This is only

temporary.

IGNITION

OPERATION

CAUTION : Always make sure that there is sufficient ventilation.

LC-32F (GB) 12.9.3 11:39 AM ページ 5

This manual is related to the following products:

LC-S27 LC-41 LC-52 LC-40 LC-43