Thrustmaster T100 FFB - Manual (Page 3)

2/10
SETTING UP THE RACING WHEEL
Attaching the racing wheel to a table or a desktop
- Place the racing wheel on a table or any other horizontal, flat and stable surface.
- Insert the fastening screw in the attachment system, then tighten the device by turning the screw
counterclockwise, so that it feeds into the large threaded hole located beneath the racing wheel, until
the device is perfectly stable.
WARNING: Never tighten the screw alone, without the attachment system!
(This could damage the racing wheel).
ASSEMBLY REMOVAL
To tighten:
Turn the screw counterclockwise
To release:
Turn the screw clockwise
Attaching the racing wheel to a cockpit
- Place the racing wheel on the cockpit shelf.
- Drive two M6 screws (not included with the racing wheel) through the cockpit shelf, then feed them into
the two small threaded holes located beneath the racing wheel.
- Then, tighten the standard attachment system by inserting the fastening screw in the large threaded
hole.