Tempest XYZ - Manual (Page 2)

Tempest Lighting, Inc
13110 Saticoy Street, Unit C, North Hollywood, CA 91605, USA
www.tempest.org [email protected]
t: +1 818 787 8984 f: +1 818 982 5510
6500.XYZ.T – Pipe/Truss Mounting
The 6500.XYZ.T mount is designed to attach to any horizontal pipe
or truss member with diameter 1.75-2”[45-50mm]. If you need to
attach to a larger diameter pipe you may do so by replacing the two
Proburger Clamps with any industry standard rigging clamp, with a
1/2”-13 bolt.
1. Remove the nuts and washers from the two collar bolts.
2. Remove the Safety Locknut from the Safety Bolt
3. Re-assemble the clamp assembly onto the yoke plate
4. Re-attach the nuts and washers, and tighten with a suitable
wrench.
NOTE: You can assemble either with the clamp plate parallel or
perpendicular to the yoke plate. In either case you can pan 45°
either side of center.
NOTE: DO NOT OVERTIGHTEN — you should be able to rotate
the clamp assembly on the yoke plate.
SAFETY WARNING: YOU MUST MAKE SURE THAT THE SAFETY
BOLT AND LOCKNUT ARE SECURELY FITTED.
5. Assemble the XYZ Mount to the enclosure, using the four bolts
and spring nuts on the XYZ Mount cradle. Be sure to twist the
spring nuts into the Unistrut rails so that they grip securely.
6. Adjust the position of the XYZ Mount along the Unistrut chan-
nels to position as close as possible to the center of gravity
(see figure 2).
7. Lift the enclosure onto the truss or horizontal pipe pipe - THIS
REQUIRES TWO PEOPLE - and secure the two Proburger clamps
to the pipe.
Adjusting Pan, Tilt and Roll
Pan Adjustment – Vertical Pole Mount
•
You may rotate the enclosure 360° and lock in place by tight-
ening the Pan Locking Knob
Pan Adjustment – Truss Mount
•
Rotate the enclosure up to 45° either side of center axis, and
lock by tightening the two Collar Bolt Nuts.
• NOTE: you may rotate more than 45° by backing out the two
collar bolts, rotating the Clamp Assembly 90°, and replacing
the Collar Bolts in the perpendicular holes in the Clamp As-
sembly.
Tilt Adjustment
•
Loosen the Tilt Knobs both sides and adjust tilt up to ±90°,
then tighten the Tilt Knobs to lock.
• NOTE: With larger enclosures it is important to check that the
XYZ Mount is located at the center of gravity of the enclosure
to ensure a positive lock.
Roll Adjustment
•
You can adjust the roll of the enclosure ±10°.
• First, loosen the Roll Locknuts on all four Roll Screws (figure
4).
• USe a wrench to turn the Roll Screws to raise or lower each
side of the XYZ Mount Cradle to the desired position.
• Tighten the Roll Locknuts up onto the Yoke Plate to secure.
2”[50mm]
Proburger Clamp
Clamp Assembly
Collar Bolt
Collar Bolt Nut
Safety Bolt
Safety
Locknut
Yoke Plate
Alternate
perpendicular
Collar Bolt holes
Spring Nuts Figure 3
Figure 4
Pan Locking
Knob
Tilt Knob
Roll Locknut
Roll Screw
Yoke Plate
Adjust position of XYZ
Mount along the Unistrut
rail to balance the
enclosure for positive tilt
locking
Unistrut Rail