Site selection and preparation – Dimplex DFO3607 User Manual
Page 6
NOTE 1
A 15amp, 120 volt outdoor GFI is required. Additional appliances on the same circuit may
exceed the current rating of the circuit breaker.
WARNING
Ensure the power cord and transformer are not installed so that it is pinched or against a
sharp edge and ensure that the cord and transformer are stored or secured to avoid tripping
or snagging to reduce the risk of fire, electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local building codes and other
applicable regulations to reduce the risk of fire, electric shock and injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric
shock or injury to persons, always use a licensed electrician.
SITE SELECTION AND PREPARATION
This section provides instructions for selecting a location and preparing the site to install the
fireplace into your Dimplex mantel surround.
1. Select a suitable location.
2. For ease of electrical hook up you may wish to locate the fireplace near an existing
outlet. (refer to NOTE 1).
NOTE
The dimensions of the fireplace are 37.60”wide X 26.25” high X 11” deep. The viewing area
is 36” wide and 19.25” high.
4
20 Feet