SMK-Link Electronics RemotePoint Jade Presenter - Manual (Page 3)

Pairing the Receiver
First Use
1. Open the battery compartment by pressing down on the latch. Insert the batteries
per the diagram on the remote. Standard AA alkaline batteries are recommended.
2. With the computer turned on, plug the receiver into a
free USB port. (If the computer displays a “Found New
Hardware” dialog box, click Next until the driver is
installed.)
The receiver and remote come pre-paired at the factory. The remote will
automatically adjust frequencies and channels to ensure reliable
communication. Should you have any problem with
communication, you can re-pair them by plugging
the USB receiver into the AutoRF Port on
the back of the remote.