Oxmoor MCS - Manual (Page 28)

Page 26
*SMPTE Method; 60 Hz + 7 kHz mixed 4:1.
** Input terminated w/600 ohms, unity gain, adjacent channel driven to +4 dBm output.
Specifications subject to change without notice.
AUDIO IN AUDIO IN AUDIO IN AUDIO IN AUDIO IN Type ............................................................... Electronically Balanced (RF Suppressed)
Connectors ..................................................... Screw Terminal Blocks
Input Impedance ............................................ 80 k Ohms
Maximum Input Level ..................................... +24 dBu
CMRR ............................................................ 50dB @ 1kHz
FREQUENCY RESPONSE FREQUENCY RESPONSE FREQUENCY RESPONSE FREQUENCY RESPONSE FREQUENCY RESPONSE 20 Hz to 20 kHz ............................................. +0, -0.3 dB
-3 dB Points, Ref. 1 kHz .................................. 4 Hz to 70 kHz (+4 dBm Output)
HUM AND NOISE HUM AND NOISE HUM AND NOISE HUM AND NOISE HUM AND NOISE Ref. +4 dBm Output @ Unity Gain ................... -85 dB (20 Hz to 20 kHz, Unweighted)
DISTORTION DISTORTION DISTORTION DISTORTION DISTORTION Total Harmonic (THD + NOISE)
Ref. +4 dBm Output @ Unity Gain ................... -80 dB/0.01% (20 Hz to 20 kHz)
Ref. +4 dBm Output @ Unity Gain
SMPTE IMD* ............................................. -80 dB/0.01%
Transient IMD ............................................ -80 dB/0.01%
CROSSTALK & OFF ISOLATION CROSSTALK & OFF ISOLATION CROSSTALK & OFF ISOLATION CROSSTALK & OFF ISOLATION CROSSTALK & OFF ISOLATION Channel to Channel** ..................................... -85 dB (20 Hz to 20 kHz)
Driven Input to Off Output ............................... -85 dB (20 Hz to 20 kHz)
GAIN CONTROL RANGE GAIN CONTROL RANGE GAIN CONTROL RANGE GAIN CONTROL RANGE GAIN CONTROL RANGE Ref. 0 dBu Output .......................................... + 15 dB TO - 45 dB
PAGE PAGE PAGE PAGE PAGE Connector ...................................................... Screw Terminal Blocks
Input Type ...................................................... Active Low, Internally Pulled Up
Input Protection .............................................. 1/2 Max. Line Voltage, 12 kV Static
Logic Action ................................................... Maintained Closure to Common
Logic Levels (at Terminal Block) ...................... Low < .8 Volts, High > 2.4 Volts
Maximum Sink Current ................................... 1 mA
Maximum Cable Length .................................. 600m (2000 ft), #22 AWG
Switching Time ............................................... 50 ms
HEAD 1 THROUGH HEAD 8 HEAD 1 THROUGH HEAD 8 HEAD 1 THROUGH HEAD 8 HEAD 1 THROUGH HEAD 8 HEAD 1 THROUGH HEAD 8 Connector ...................................................... Screw Terminal Blocks
Output Type .................................................... Open-Collector Darlington to Common
Max. Sink Current .......................................... 500 mA
Max. Voltage ................................................... 50 VDC
POWER POWER POWER POWER POWER Connector ...................................................... Screw Terminal Blocks
Maximum Voltage ........................................... 50 VDC
PA-422 IN PA-422 IN PA-422 IN PA-422 IN PA-422 IN Type ................................................................ Serial Interface, PA-422
Connector ....................................................... Male, 9-pin D-sub
PA-422 OUT PA-422 OUT PA-422 OUT PA-422 OUT PA-422 OUT Type ................................................................ Serial Interface, PA-422
Connector ....................................................... Female, 9-pin D-sub
PA-422 ADDRESS PA-422 ADDRESS PA-422 ADDRESS PA-422 ADDRESS PA-422 ADDRESS Type ................................................................ 8 position selector switch
Address Select ................................................ 1 through 250
MCS-CC CONTROL CARD SPECIFICATIONS
MCS-LC LOGIC CARD SPECIFICATIONS