OT Systems FT080CF - Manual (Page 5)

FT080CF Series Installation & Operation Manual
www.ot-systems.com 5
(2) Product Overview
2.1 Introduction
The FT080CF Series products comprise of either single-mode or multi-mode fiber optic
transmitters and receivers for the optical transmission of EIGHT forward (Tx → Rx) contact
closure signals all on one fiber. The products work at wavelengths of 1310nm or 1550nm with
either a 9/125um or 62.5/125um fiber for single-mode or multi-mode transmission respectively.
Forward transmission of Contact Closure (CC) status is supported. The CC input can be a
Dry contact or a TTL logic input. Normally Open (NO) or Normally Close (NC) Contact selectable
output is provided for a maximum current of 1000mA at 110VDC/125VAC.
For single-mode transmission, we also offer specifically designed products for long-haul
transmissions up to 60km. These models include the letter “L” in the suffix, e.g. FT080CF-SSTL
for Tx, FT080CF-SSRL for Rx, etc.
The FT080CF Series units are available as standalone units, which can be mounted
horizontally or vertically wall-mounted on any fixture. The standalone unit comes with an external
power supply FT-PA/12V, which can be powered by local 110/220V power.
The FT080CF Series units are also available as plug-in card modules installed in a 19”
rack-mount chassis. Each plug-in card occupies two slots in the rack-mount chassis. The rack
mount chassis has to be ordered separately, and comes with its own power supply for powering
the installed card modules.