OT Systems FT410DBE - Manual (Page 15)

FT410DBE Series Installation & Operation Manual
www.ot-systems.com 15
ELECTRICAL VIDEO
Channel / Connector 4 / BNC
System PAL, NTSC, SECAM
Bandwidth ≥ 6.0 MHz
Input/Output Impedance 75 Ohm
Input/Output Level 1.0 Vp-p typical
Differential Gain < 1% typical
Differential Phase < 1
o
typical
SNR >65dB
DATA
Channel / Connector 1 / 7-pin Screw Terminal
Direction Bi-directional (Duplex)
Electrical Format RS232, RS422, RS485 (2-wire, 4-wire) Tri-state
Transmission Rate 0~256Kbps
Ethernet
Channel (Connector) 1 (RJ45 Connector Jack)
Direction Duplex
Transmission Format 10/100 Base T; Full duplex
POWER
Power consumption 12VDC @ 6W
Power Supply Standalone Unit: FT/PA12V DC Adaptor
Card module: Powered by FT-C18 chassis
Connector (Standalone unit) 2-pin Screw Terminal
PHYSICAL
Weight Standalone unit: 0.8 kg Card module: 0.32 kg
Dimensions (W x H x D) Standalone unit: 156 x 50.5 x 223 mm (MAX)
Card module: 148 x 41 x 213 mm (MAX)
ENVIRONMENTAL
Operating Temperature -40
o
C ~ +75
o
C
Storage Temperature -40
o
C ~ +85
o
C
Relative Humidity 0 ~ 95% non-condensing
MTBF >100’000 Hours
*
If the optical connector is FC type, the suffix in the model number will be “-FXX”. Eg. FT410DBE-FST