OT Systems ET1100C series - Manual (Page 8)

ET1100C Series Installation & Operation Manual
www.ot-systems.com 8
4.2 Connecting to Your Network
Cable Type & Length
It is necessary to follow the cable specifications below when connecting the Ethernet
Extender to your network. Use appropriate cables that meet your speed and cabling
requirements.
Cable Specifications
4.2.1 The 10/100Base-TX Connector
A standard straight through cable is used for the connection between the Ethernet switch and
device. For the details, Please see Appendix A for your reference.
4.2.2 The BNC connector and Coaxial Cable
For the Ethernet Extender port
4.3 Cabling
Step 1: First, ensure the power of the Ethernet Extender and end devices are turned off.
Always ensure that the power is off before any installation.
Step 2: Prepare cable with corresponding connectors for each type of port in use.
Step 3: Consult the previous section for cabling requirements based on connectors and speed.
Step 4: Connect one end of the cable to the Ethernet Extender and the other end to a desired device.
Step 5: Once the connections between two end devices are made successfully, turn on the power and the
Ethernet Extender is operational.
Speed Connector Cable Max.
Distance
10Base-T RJ-45 2-pair UTP/STP Cat. 3, 4, 5 100 m
100Base-TX RJ-45 2-pair UTP/STP Cat. 5 100 m
Connector Cable Max.
Distance
BNC (75Ω) Coaxial Cable (RG6, RG58 or RG59) 300m