Assembly, startup, and dismantling, Functional description, Installation – OT Systems ET1100C2 series User Manual
Page 4
ET1100C2 Series
Industrial 10/100Base-TX Ethernet plus CVBS Over Coax Converter
4
V1.3
The Port Status LEDs, dimension drawing of the Micro unit
Indicator
Color
Description
PWR
Green
Power on.
Off
Power off.
COAX
DATA
LINK
Green
The COAX DATA link
(between TX & RX) is
established.
ACT
Flashing
Data is being
transmitted or received.
ACT Stands for Activity.
CVBS IN (TX only)
Green
Video input
CVBS OUT (RX only)
Green
Video output
10/100
(Ethernet)
SPD
Orange
100Base-TX
Off
10Base-TX
LINK/ACT
Steady
A valid network
connection is
established
Flashing
Data is being
transmitted or received.
ACT Stands for Activity.
Functional Description
Ethernet Extension : Security Link over Coax
Simultaneous transmission of IP and CVBS over single coaxial cable
Constant Data Rate : 36Mbps(Downlink)/11Mbps(Uplink)
Maxiumum distance : 300m over Coax(RG-59/U)
Support Auto MDI/MDI-X
-10
℃ to 60℃ operating temperature.
Assembly, Startup, and Dismantling
Installation
Installation: Mount the Micro type unit onto a fixture, or camera housings, e.g. a plank, (either on the wall or on
a flat surface) with at least 2 screws piercing through the holes on the mounting frame to secure it in position.
Startup: Connect the supply voltage to start up the Media Converter via the terminal block.
Dismantling: Locate and remove the securing screws. Usually, but not limited to, at least 2 screws.
Manual Earth Green manual is available on our website