OT Systems ET1100CPp series - Manual (Page 2)

ET1100CPp Series
Industrial 10/100Base-TX Ethernet over Coaxial Converter with PoE+ & PoC
V1.3 2
Connecting to Power
The EoC converter is a plug-and-play device. The TX and RX support two type of power input.
Receiver (RX)
1. External Power Adapter - Connect an AC to DC power adaptor (48VDC output) to the power connector (2 pin
terminal block) of the receiver, and then attach the plug into a standard AC outlet. The PWR LED will then be lit.
2. Power over Ethernet (PoE) - Connect the Ethernet cable from an Ethernet switch with high power PoE (PoE+) to
the RJ45 (10/100) of the receiver, the PWR LED will then be lit. In this case, power adapter is not needed.
Transmitter (TX)
1. External Power Adapter - Connect an AC to DC power adaptor (48VDC output) to the power connector (2 pin
terminal block) of the transmitter, and then attach the plug into a standard AC outlet. The PWR LED will then be
lit.
2. Power over Coax (PoC) - If the transmitter has not connected with a power adapter, when the coaxial cable is
properly connected between the transmitter and receiver, the transmitter can get the power from the remote
receiver through the coaxial cable. The PWR LED will then be lit.
.
Connecting to Coax
Connect the coaxial cable to the female BNC connector (COAX DATA) of the transmitter and receiver. If the
transmitter and receiver are properly connected and communicated with each other, the Link LED (LINK) near the
COAX DATA port of the transmitter will be lit (ON). The PoC LED of the receiver will be lit too when the PoC is in use.
Connecting to Ethernet
Connect the Ethernet cable from the IP camera to the Ethernet port (10/100) of the transmitter. If the cable is
properly connected, the LINK/ACT LED of the Ethernet port of the transmitter will start flashing. When the connected
camera is a PoE IP camera, the transmitter will supply power to the camera through the Ethernet port via the
Ethernet cable and the PoE LED will be lit. Connect the Ethernet cable from the NVR or an Ethernet switch or similar
equipment to the Ethernet port (10/100) of the receiver. If the cable is properly connected, the LINK/ACT LED of the
Ethernet port of the receiver will be lit.
Power Connector
Pin
Description
- +
Power Input GND
48V~57V
(DC)
- +