One Systems Pole Mount Mini - Manual (Page 7)

The cable assembly MUST be assembled AFTER the enclosure is mounted to
the bracket and the bracket is suspended. See Figure 5 for detail of the finished
assembly.
The cable assembly consists of a length of 1/16 inch stainless steel wire rope,
two ¼ inch stainless steel thimbles, and two oval sleeves. The ¼ inch thimbles
must be spread to fit over each of the eyebolts. The wire rope should be
configured and the sleeves crimped AFTER the thimbles have been installed
around the eyebolts. The cable parts are shown in figure 3. The length of the
wire rope is determined by the pan and tilt angles of the enclosure.
Figure 3
Figure 3 is a photograph of the wire rope section and one of the thimbles as well
as one of the oval sleeves. Make sure that the oval sleeve is crimped using the
proper crimping tool. A close view of the assembly is shown in Figure 5.
NOTE: A special crimping tool is required for stainless steel compression
sleeves. The use of a tool that is not approved for use with stainless steel
compression sleeves will result in reduced ratings for the wire rope assembly.
The proper tool to use is produced by:
Loos and Company, Cableware Division
901 Industrial Blvd.
Naples, Fl 34104-3715
1-800-321-5667
The correct tool is:
No. 0-3/64SC
This tool is designed for use with stainless steel compression sleeves. This
tool or the equivalent must be used when swaging the compression
sleeves. When crimping stainless steel compression sleeves you MUST