Oklahoma Sound #112 User Manual
Page 4
4
5
O
klahOma
S
Ound
C
OrpOratiOn
A/V CART: Model 112
installation oF hardware
1) Lay out the wood panels as shown below in figure "A" (make
sure the factory drilled holes are facing upwards).
2) Identify the holes numbered "1" in Diagram A. screw the
bolts into the holes with the #2 Phillips Head screwdriver. Be
sure to tighten the screws all the way. Note: Be careful not to
over-tighten the bolts as this will strip the wood.
3) The cams should be inserted in the larger holes as shown
on the Diagram "A". MAKE SURE THE ARROW ON THE CAM IS
POINTING TO THE CLOSEST EDGE AND ALIGNED WITH THE
HOLE ON THE EDGE.
Diagram "A"
assembly oF lectern
It is important that the instructions on the assembly are
followed carefully
1) Panel E the first piece of equipment that will be in-
stalled will be the shelf. Make sure the cams will face
the bottom of the lectern. The two bolt in the center
of Panel A (the right hand panel) will align with the
two holes on the edge of the shelf Panel E (these holes
reach until the cams) gently push the panel down on to
the cam bolts until the panel is completely on the right
side Panel A. Tighten the cams by turning clock-wise
until locked (Diagram B).
2) Apply Panel C to the second side of the shelf. Tighten
cams (Diagram C)
Diagram "B"
Diagram "C"
A
B
C
E
D