nMediaPC HTPC 1080i - Manual (Page 2)

2
Installation Flowchart (Basic Procedures)
Installation Tools
Screw driver / Screws / Tight cables / Installation guides
Step 1: Remove bottom cover and bring out PSU
1. Connect the PSU cables.
a. 24 Pins Head to the PSU board
b. Connect the “Power Board” label to the PSU Board
c. If you are not using a built in Power motherboard, i.e. Zotek, you must install the Power
In cable that connects to the power adaptor and the other end to the power Module.
Otherwise, you will need to un-install the motherboard if you miss this step.
Note: The header with the 12V (4 pins) connector goes to the power module, otherwise, your HDD
SATA Power Cable will be short to connect to the HDD
2. Install the modulated 1080IP PSU board to the case left side and secure it with 2 screws.
Step 2: Install Motherboard and Connect Cables
1. Slide in the I/O Board
2. Install motherboard
3. Install Memory; CPU (if needed)
4. Connect 24 pins cable and USB cable to onboard port
5. Connect DVD ROM Power cord to PSU DVD ROM port
Open box Æ Remove bottom cover Æ Read installation guides Æ Assemble Power Supply (1080IP) Æ
Intall Power In Cable that connects the Power Adaptor and PSU Module (If you don’t have built in
onboard PSU)
Æ Install I/O Plate Æ Install motherboard Æ Install Power Supply Æ Install memory / CPU
Æ Connect cables Æ Install 2.5” HDD Æ Install Connect HDD cables Æ Re-install bottom cover Æ Install
case feet
Æ Install Slim drive