beautypg.com

NEXCOM VTC 6110 User Manual

Page 18

background image

Copyright © 2009 NEXCOM International Co., Ltd. All Rights Reserved.

4

VTC 6110 User Manual

Chapter 1: Product Introduction

Power Management

Power-on delay time is selectable by BIOS to disable and enable in 10sec

/ 30sec / 1min / 5min / 10 min / 15min / 30min / 1hr.
Power-off delay time is selectable by BIOS to disable and enable in 20sec

/ 1min / 5min / 10min / 30min / 1hr / 6hr / 18hr.
S3, S4 suspend mode


• Ignition On/Off status detectable by SW
• Low battery status detectable by SW

Ignition enable/disable is jumper selectable

Shut down system automatically when the system’s internal temperature

is over 80C.
VTC 6110 will automatically shut down 5 minutes after the duration

of low battery voltage is over 60 sec. User can detect this situation via
software.
If the ignition is off and the system is still on after 3 minutes, VTC 6110

will shut down automatically.
If the ignition is off, the user can detect this status via the software.

If the ignition is turned on again and the power-off delay is in progress,

VTC 6110 will cancel the delay function and will continue to operate
normally.
If the ignition is turned on again and the power-off delay ended, VTC

6110 will shut down completely will power-on again automatically.
If the ignition is turned off again and power-on delay is in progress, VTC

6110 will cancel the delay and stay in power-off status.
If the ignition is turned off again and the power-on delay ended (en-

tered OS already), VTC 6110 will continue to operate normally.

If the ignition is turned off again and the power-on delay ended (in BIOS

process), VTC 6110 will shut down immediately.
If VTC 6110 is off, only below 10mA is used.