Graphics configuration, Amt configuration – NEXCOM NDiS B533 User Manual

Page 58

NDiS B533 User Manual

Chapter 4: BIOS Setup

Graphics Configuration

This section is used to configure the graphics parameters.

Advanced

Boot

Security

Save

Exit

Main

→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit

Select the Video Device which

will be activated during POST.
This has no effect if external

graphics present.
Secondary boot display selection
will appear based on your
selection.

VGA modes will be supported
only on primary display

Primary IGFX Boot Display

Secondary IGFX Boot Display

[HDMI1]

[HDMI2]

Primary IGFX Boot Display
Select the Video Device which will be activated during POST. This has no
effect if external graphics present. Secondary boot display selection will
appear based on your selection. VGA modes will be supported only on
primary display. The options are VBIOS Default, HDM1, HDMI2 and HDMI3.

Secondary IGFX Boot Display
Select the secondary display device, the options are Disabled, HDMI1,
HDMI2 and HDMI3.

AMT Configuration

This section is used to configure Active Management Technology (AMT)
options.

Advanced

Boot

Security

Save

Exit

Main

→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit

Enable/Disable Intel (R) Active

Management Technology BIOS
Extension.

Note : iAMT H/W is always
enabled.
This option just controls the

BIOS extension execution.
If enabled, this requires
additional firmware in the SPI
device

Intel AMT

BIOS Hotkey Pressed

MEBx Selection Screen

[Enabled]

[Disabled]

Intel

AMT

Enables or disables Intel

Active Management Technology.

BIOS Hotkey Pressed
Enables or disables BIOS hotkey press.

MEBx Selection Screen
Enables or disables MEBx selection screen.