NEXCOM NDiS 163 User Manual

Page 37

Text mode
Original mode

Chapter 3: System Setup

NDiS 163 User Manual

3. Note how the module is keyed to the socket. Grasping the module by

its edges, align the module with the socket so that the “notch” on the
module is aligned with the “key” on the socket. The key ensures the
module can be plugged into the socket in only one direction.

Notch

Key

4. Insert the module into the socket at an approximately 30 degrees

angle. Apply firm even pressure to each end of the module until it slips
down into the socket. The contact fingers on the edge of the module
will almost completely disappear inside the socket.

The ejector tabs at the ends of the socket will automatically snap into
the locked position to hold the module in place.