NEXCOM ICES 668 - Manual (Page 104)

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved. 90 ICEK 668-T6 Starter Kit User Manual
Appendix B: GPI/O Programming Guide
Appendix B: GPI/O Programming Guide
GPI/O (General Purpose Input/Output) pins are provided for custom system design.
This appendix provides definitions and its default setting for the ten GPI/O pins in the
ICES 668 series. The pin definition is shown in the following table:
Pin No. GPI/O mode PowerOn
Default
Address Pin No. GPI/O mode PowerOn
Default
Address
1 VCC - - 2 GND - -
3 GPI0 Low 548h (Bit6) 4 GPO0 High 548h (Bit7)
5 GPI1 Low 50Eh (Bit1) 6 GPO1 High 50Ch (Bit7)
7 GPI2 Low 548h (Bit4) 8 GPO2 High 538h (Bit6)
9 GPI3 Low 548h (Bit5) 10 GPO3 High 538h (Bit7)
Control the GPO pin (3/5/7/9) level from I/O port 548h, 50Eh, 548h, 548h bit (6/1/4/5).
The bit is Set/Clear indicated output High/Low