Ir inputs, Via ir remote, Standby mode – NeoPro Vandenberg User Manual
Page 8
8
3) Serial Commands via TCP/IP
IR Inputs
Located on the front panel is a small box labeled “IR sensor” where IR codes
can be received. If your system makes use of IR emitters from a control system,
this is the correct location to attach the emitter.
Via IR Remote
There are three power buttons on the IR remote.
Power Toggle – Changes power state from current state
Power On – Always turns on, regardless of current state
Power Off – Always goes to standby, regardless of current state
Standby Mode
When in Standby Mode, all outputs are virtually disconnected. The HDMI ports
are in standby mode and will consume less power.