Care and maintenance, Caution, Changing the engine oil – Dixon 13088-1100A User Manual
Page 29
Page 29
CARE AND MAINTENANCE
CAUTION
HOT oil may cause burns. Allow engine to cool before draining oil.
PLEASE DISPOSE OF USED OILS AT PROPER COLLECTION CENTERS.
-PROTECT YOUR ENVIRONMENT-
CHANGING THE ENGINE OIL:
1. The "Dapco" oil drain valve is located on the left side of the engine crankcase
(Model 4515B) and on the right side of the engine crankcase (Model 4516K).
2. Place a suitable container under the drain valve. The fitting of a short piece of hose
will help direct the oil.
3. To drain turn hex head valve stem counter clockwise with 10mm wrench or socket.
Open to full open (approximately 7 turns).
4. After engine is drained tighten hex stem.
NOTE: Refer to engine manufacturers recommendations for frequency of oil changes.
OIL FILL
:
1. Drain oil.
2. Clean any spilled oil from engine and chassis.
3. Refill engine with type, and quantity of oil recommended by the engine
manufacturer in engine literature.
NOTE: Engine oil changes on the 4500 Series Models will require replacement of the oil filter.
These filters can now be obtained from any authorized Dixon Dealer.
Hex Head Valve Stem