Dixon 13088-1100A - Manual (Page 11)

Page 11
SPECIFICATIONS
Models ZTR 4515B and 4516K
CHASSIS: Twin 12 gauge side frames and 7 gauge transmission and engine base plate.
BODY: All body parts are made of high density polyethylene. Dent and corrosion resistant.
Front body contains access panel for battery service.
MOWER DECKS: 42" Deck: 13 GA Stamped Steel Construction - 42" Cut Width
50" Deck 11 GA Fabricated Construction/Reinforcement Ribs - 50" Cut Width
Cut height approximately 1" to 4" via 7 position lift handle.
BLADE DRIVE: Electric clutch.
TRANSMISSION: Each rear wheel is independently driven by a HydroGear IZT hydrostatic drive.
ENGINE:
Model 4515B: 15.5 HP Vanguard Briggs & Stratton, 4-Cycle, Single Cylinder, Overhead Valve,
Air-Cooled, Gasoline, Vertical Shaft With Cast Iron Cylinder Sleeve, Oil Pump
With Integral Oil Filter.
Model 4516K: 16 HP Kohler Command 16, 4-Cycle, Single Cylinder, Overhead Valve, Air-
Cooled, Gasoline, Pressure Lubricated, With Oil Filter, Vertical Shaft, Aluminum
Head and Block with Cast-Iron Cylinder Liner. Smart Spark Ignition.
STARTING SYSTEM: Electric by key switch operation with safety interlock blade drive.
TIRES: Front 11 X 4.00 X 5 ribbed tread.
Rear 18 X 8.50 X 8 Multi-Trac
RECOMMENDED
TIRE PRESSURE:
Front 16-21 lbs.
Rear 8-14 lbs.
CAPACITIES: Fuel 2.7 gallons total.
Engine Briggs & Stratton - 1.50 quarts oil.
Kohler - 2 quarts oil with filter.
DIMENSIONS: Width 44" Maximum Track Width
Height 42" to top edge of seat.
Length 72" hitch tab to front bumper.
Weight Power Unit: 463 lbs.
w/42" Deck: 547 lbs.
w/50" Deck: 603 lbs.
NOTE: Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE