ILUMINARC Ilumipod™ Inground Tri-3 IP - Manual (Page 17)

Technical Information
Ilumipod Inground Tri-3 IP Optic 25 WW User Manual Rev. 5 13
5. Technical Information
Always dry the
external optics
and glass
surfaces carefully
after cleaning them.
If you still
experience
technical
problems after
trying the solutions in the
Troubleshooting Table,
contact
ILUMINARC ®
Technical Support .
Product Maintenance
To maintain optimum performance and minimize wear, clean the products frequently. Usage
and environment are contributing factors in determining the cleaning frequency. As a general
guideline, products should be cleaned at least twice a month. Dust build-up reduces light
output, performance, and can cause overheating. This can lead to reduced light source life.
For products containing external optical lenses, clean them periodically to optimize light
output. The cleaning frequency depends on the environment in which the product operates.
Damp, smoky, or particularly dirty surrounding can cause greater accumulation of dirt on the
product’s optics, requiring more frequent cleaning.
To clean a product:
· Disconnect the product from power.
· Wait until the product is at room temperature.
· Use a vacuum (or dry compressed air) and a soft brush to remove dust collected on the
external surfaces.
· Clean all external glass optics and glass surfaces with a mild solution of glass cleaner or
isopropyl alcohol, and a soft, lint-free cotton cloth or lens-cleaning tissue.
· Apply the solution directly to the cloth or tissue and wipe any dirt and grime to the outside
edge of the lens. Gently polish the external glass surfaces until they are free of haze and
lint.
Product Repairs
ILUMINARC® strongly advises you against attempting any repairs to this product unless you
are an authorized ILUMINARC® technician.
ILUMINARC® presents the information contained in the
Troubleshooting Guide as potential
solutions only. In most cases, opening the product’s housing will invalidate its warranty.