ILUMINARC Ilumipod™ Inground Tri-3 IP - Manual (Page 6)

Ilumipod Inground Tri-3 IP Optic 25 RGB QRG
6
Ilumicon and
DMX
Controllers
The Ilumipod Inground Tri-3 IP Optic 25 RGB can operate with either
an Ilumicon or a DMX controller. Use the standard DMX connection,
as shown on page 4 (DMX Junction Box Wiring) to connect this
product to any of those controllers. For more information, please refer
to the Ilumipod Inground Tri-3 IP Optic 25 RGB User Manual.
Settings The Ilumipod Inground Tri-3 IP Optic 25 RGB uses the Ilumicode unit
for configuration purposes.
Ilumicode
Connections
The diagram below shows how to connect the Ilumicode to this
product.
Connecting the Ilumicode will control multiple products at the same
time, all having the same DMX address. To assign individual DMX
addresses to each product, you must connect the Ilumicode unit to each
product individually. You will also have to disconnect the DMX
output of the product being configured if other products are connected
to it.
Ilumicode
Connection
Diagram
ILUMINARC® suggests connecting no more than 20 products in this
mode, keeping the total distance to less than 60 m (197 ft). If not, you
may need to use an optically isolated signal amplifier.