ILUMINARC Ilumipod™ Inground Tri-12 IP - Manual (Page 4)

Ilumipod Inground Tri-12 IP
4
Beam Angle
Adjustment
The Ilumipod Inground Tri-12 IP has two LED modules. You can adjust the
angle of each of these modules to spread or narrow the fixture’s beam. To
do so, follow these steps:
· Loosen the ¼ turn Allen bolts on the stainless steel collar.
· Lift the fixture from the installation sleeve, making sure not to stretch
the power and signal cables.
· Loosen the six nuts that hold the collar to the housing, except two
adjacent ones.
· Wait a few seconds for the seal to expand. This lowers the possibility of
damaging the seal.
· Complete the removal of the two remaining nuts.
· Remove the stainless steel collar.
· Carefully, lift and remove the protective glass and seal. Make sure not
to reverse the glass.
· Using only your hands, push on the sides of each module to adjust its
angle, as shown in the figure below.
· Replace the glass and seal.
· Replace the stainless steel collar, making sure to allow the Allen screws
to show and that the glass is flushed with the collar.
· Replace all six nuts and adjust them manually until they touch the
housing.
· Tighten the nuts uniformly by alternating between opposite nuts.
· Reattach the fixture to the installation sleeve.