ILUMINARC Ilumipod™ 18g2 IP - Manual (Page 15)

Operation
Ilumipod 18g2 IP Optic RGB User Manual (Rev. 2) 11
4. Operation
When you scroll
through the
menu options,
you will see
many of them that do not
correspond with the menu
map. Skip them, as they
do not work with the RGB
only output products.
ILUMICODE ADDRESSER
To use the Ilumicode to change the configuration of the Ilumipod 18g2 IP Optic RGB, follow
these instructions.
Ilumicode Panel Description
Control Options
You can set the Ilumipod 18g2 IP Optic RGB start address in the 001~512 DMX range. This
allows for the control of up to 73 products in the 7-channel ARC FULL personality.
Programming
Carry out all the programming procedures indicated below from the control panel. Refer to the
Menu Map section to learn how the menu options relate to each other.
Use and
DMX Personality
1. Go to PERSON and select any DMX personality.
2. Make sure to rearrange the DMX addresses of all products in the current DMX
universe to avoid address overlapping.
DMX Starting Address
1. Go to DMX.
2. Select a starting DMX address (001~512).
Button Function
Enables the currently displayed menu or sets the
currently selected value into the selected function
Navigates upwards through the menu list and increases
the numeric value when in a function
Navigates downwards through the menu list and
decreases the numeric value when in a function
Turns the unit on. The unit will turn off automatically
after 30 seconds of inactivity