ILUMINARC Ilumipod™ 18g2 IP - Manual (Page 11)

Installation
Ilumipod 18g2 IP Optic RGB User Manual (Rev. 2) 7
Always connect
the Ilumipod
18g2 IP Optic
RGB to a protected circuit
with an appropriate
electrical ground to avoid
the risk of electrocution or
fire.
Never connect
the Ilumipod 18g2
IP Optic RGB to a
rheostat (variable resistor)
or dimmer circuit, even if
the rheostat or dimmer
channel serves only as a
0% to 100% switch.
Make sure to
connect the
Ilumipod 18g2 IP
Optic RGB to a power line
with the proper voltage
and frequency, as per the
specifications in this
manual or on the
product’s sticker.
AC Power
The Ilumipod 18g2 IP Optic RGB has an auto-ranging power supply that works with an input
voltage range of 100~240 VAC, 50/60 Hz.
Make sure that you are connecting this product to the proper voltage, as per the specifications in
this User Manual or on the product’s sticker.
Power Consumption
To determine the power requirements for the Ilumipod 18g2 IP Optic RGB, refer to
the label affixed to the side of the product. You may also refer to the
Technical
Specifications .
The listed current rating indicates the maximum current draw during normal operation.
AC Plug
The Ilumipod 18g2 IP Optic RGB comes with a bare-ended power input cord for
hardwire installation. Use the table and the illustration below to wire a plug.
Connection Wire (U.S.) Screw Color (U.S.) Wire (Europe) IP67 Pin
AC Live Black Yellow or Brass Brown 1
AC Neutral White Silver or Gray Blue 2
AC Ground Green/Yellow Green Green/Yellow 3
The listed
current rating
indicates the
maximum
current draw during
normal operation.
If you choose to
bury the power or
signal distribution
boxes, make sure that
they are IP67-rated or
greater.
Power Wiring
You can connect the bare-ended, IP67-rated AC power cable from the product to an
IP67-rated power connector or IP67-rated junction box.
If using junction boxes, make sure to use IP67-rated conduit for surface installations.